Cart (0)
Close
-
SuperVolcano 80W Heater
£15.84SuperVolcano heater cartridge These 80W heaters have been designed specifically for the needs of the SuperVolcano HotEnd and provide the much-needed power in order to achieve the highest flow rate possible. These have an extra-long 47.50mm heater cartridge that runs the full length of the SuperVolcano block. The 12V heater cartridge is supplied with a MOSFET as the current draw is up to 8A The 24v heater cartridge is not supplied with a MOSFET as the current draw is only 3.9A -
Standard Heater Cartridge
£8.58 – £9.24Purpose made 30W and 40W heater cartridges for E3D HotEnds. These aren’t the same as the low-quality parts often seen in clones and have a considerably higher internal build quality. Please ensure you double-check the power supply before choosing either 12V or 24V. Versions: 12v 30W 12v 40W 24v 30W 24v 40W -
High Temperature Heater Cartridges (65W)
£64.66High-temperature heater cartridges Ideal for high-temperature Thermoplastics such as PEEK or PEI. These cartridges have been designed for longevity at elevated temperatures whilst reducing heat up time. While most standard 3D printer heater cartridges will reach high temperatures, they tend to fail after short service lives. If you are printing high-temperature materials, and need consistent reliable service without downtime for heater failure this is the heater you need. -
High Precision Heater Cartridges
£16.50 – £22.44Our high precision heater cartridges feature a rounder cartridge with more consistent diameter and surface quality, ensuring greater surface area contact with the heater block for more reliable heat transfer. With the quick change principle in mind, the high precision heater cartridge uses a Molex Microfit 3.0 connector enabling quick HotEnd changes. Versions: 12v 30W 12v 40W 24v 30W 24v 40W
